BWBKY - SARTOMER 244 MONOMER
- MSDS: BWBKY
- Manufacturer: SARTOMER CO INC
- Product Name: SARTOMER 244 MONOMER
- National Stock Number: 6810-00N055575
Product Identification
Product ID:SARTOMER 244 MONOMER
MSDS Date:07/27/1990
FSC:6810
NIIN:00N055575
MSDS Number: BWBKY
Responsible Party
WEST CHESTER, PA 19382
US
Emergency Phone: 215-692-8401;800-424-9300(CHEMTREC)
Info Phone: 215-363-4100
Cage: 0LKY3
Contractor
Telephone: 215-692-8401
Cage: 65093
Ingredients
ETHANOL, 2-METHOXY-, ACRYLATE; (2-METHOXYETHYL ACRYLATE)
CAS: 3121-61-7
RTECS: KL6000000
Fraction By Weight: 90%
OSHA PEL N/K
ACGIH TLV: N/K
ESTER; (OTHER ESTERS)
Fraction By Weight: 0.1%
OSHA PEL N/K
ACGIH TLV: N/K
EXPLODE DURING RUNAWAY POLYMERIZATION.
RTECS: 9999999ZZ
GIVE LUKEWARM WATER (PINT) IF
RTECS: 9999999ZZ
EXCEEDS POISONING RISK. OBTAIN EMER MED ATTN. EMER
RTECS: 9999999ZZ
OR IRRITANTS CONVENTIONALLY AFTER DECONTAM. IF
RTECS: 9999999ZZ
W/CLEAN, LOW VISCOSITY FUEL. AVOID
RTECS: 9999999ZZ
WASTE MAY BIODEGRADE. AVOID OVERLOADING/POISONING
RTECS: 9999999ZZ
NOT BLANKET/MIX W/OXYGEN-FREE GAS AS IT
RTECS: 9999999ZZ
SEPARATES AS SOLID. IF FROZEN, MATL MUST BE WARMED &
RTECS: 9999999ZZ
IN TIGHTLY CLSD, PROPERLY VENTED CNTNRS AWAY FROM
RTECS: 9999999ZZ
INITIATORS. PVNT CONTAM BY FOREIGN MATLS. USE ONLY
RTECS: 9999999ZZ
EQUIP MUST BE CLEANED THORO AFTER EACH
RTECS: 9999999ZZ
BE AVAILABLE IN THE IMMEDIATE VICINITY OF ANY
RTECS: 9999999ZZ
REMOVE SOILED CLTHG/WASH THOROUGHLY BEFORE
RTECS: 9999999ZZ
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: OVEREXPOSURE MAY CAUSE
COUGHING, SHORTNESS OF BREATH, DIZZINESS, INTOXICATION & COLLAPSE.
EYES: MAY CAUSE MODERATE IRRITATION, INCLUDING BURNING SENSATION,
TEARING, REDNESS OR SWELLING. SK IN: MODERATE SKIN IRRITANT & AN
ALLERGIC SENSITIZER. EXPOSURE TO THIS MATERIAL CAN RESULT IN (EFTS
OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: ABSORPTION THROUGH SKIN CAUSING
HEALTH HAZARD. INGESTION: SWALLOWING THIS MATERIAL MAY RESULT IN
HEALTH HAZARD. THIS MATERIAL MAY CAUSE ALLERGIC SENSITIZATION &
IRRITATION OF MUCOUS MEMBRANE S. CHRONIC: NO INFORMATION AVAILABLE
ONCHRONIC HEALTH HAZARDS OF THIS PRODUCT.
Medical Cond Aggravated by Exposure:THIS MATERIAL OR ITS EMISSIONS MAY
INDUCE AN ALLERGIC OR SENSITIZATION REACTION AND THEREBY AGGRAVATE
SYSTEMIC DISEASE.
First Aid
First Aid:INHAL: REMOVE TO FRESH AIR IMMED. GIVE OXYGEN/ARTF RESP AS
NEEDED. OBTAIN EMER MED ATTN. PROMPT ACTION IS ESSNTL. EYES: IMMED
RINSE W/CLEAN WATER FOR 20-30 MIN. RETRACT LIDS OFTEN. OBTAIN EMER
MED ATT N. SKIN: IMMED REMOVE CONTAMD CLTHG. WASH SKIN THORO W/MILD
SOAP/WATER. FLUSH W/LUKEWARM WATER FOR 15 MIN. IF STICKY, USE
WATERLESS CLEANER FIRST. SEEK MED ATTN IF ILL EFT/IRRIT DEVELOPS.
(ING 4)
Fire Fighting
Flash Point Method:PMCC
Flash Point:140F,60C
Extinguishing Media:DRY CHEMICAL, CARBON DIOXIDE, WATER SPRAY, FOAM,
WATER FOG.
Fire Fighting Procedures:NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP SEE
SECTION ON DECOMP PRODS POSS. FIGHT FIRE FROM SAFE DIST/PROT
LOCATION. HEAT/IMPURITIES MAY INCR TEMP/(SUPDAT)
Unusual Fire/Explosion Hazard:HIGH TEMPS/INHIBITOR DEPLETION/ACCIDENTAL
IMPURITIES/EXPOS TO RADIA/OXIDIZERS MAY CAUSE SPONT POLYM RXN,
GENERATING HEAT/PRESS. CLSD CNTNRS MAY RUPTURE/ (ING 3)
Accidental Release
Spill Release Procedures:RELEASE CAN CAUSE FIRE/EXPLOS. MAY POLYM &
RELEASE HEAT/GASES. EXTING ALL IGNIT SOURCES. BLANKET
W/FIREFIGHTING FOAM. IMPOUND/RECOVER LARGE LAND SPILL; SOAK UP
SMALL SPILL. ON WATER, CONTAIN/MINIMIZE DISPERSION/COLLECT. REPORT
PER REGULATORY REQS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:UNLESS INHIBITED, PROD CAN POLYM,
RAISING TEMP & PRESS, POSS RUPTURING CNTNR. CHECK INHIBITOR CONTENT
OFTEN, ADDING TO BULK LIQ IF NEEDED. DO (ING 9)
Other Precautions:FOLLOW STD PLANT PROC/SUPERVISOR'S INSTRUCTIONS FOR
DECONTAM OPERATIONS. FOR INDUS USE ONLY. KEEP OUT OF REACH OF
CHILDREN. DO NOT BREATHE VAP. USE ONLY W/ADEQ VENT/PERSONAL PROT.
CNTCT LENSES SHOULD NOT BE WORN. DO NOT TAKE INTERNALLY.
Exposure Controls
Respiratory Protection:NO OCCUPATIONAL EXPOSURE STANDARDS HAVE BEEN
DEVELOPED FOR THIS MATL. WHERE EXPOSURE THROUGH INHALATION MAY
OCCUR FROM USE, NIOSH/MSHA APPROVED RESPIRATORY PROTECTION
EQUIPMENT IS RECOMMENDED.
Ventilation:LOCAL EXHAUST VENTILATION MAY BE REQUIRED IN ADDITION TO
GENERAL ROOM VENTILATION.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGS .
Other Protective Equipment:AVOID CNTCT W/EYES, SKIN & CLTHG. PROT CLTHG
INCL APRON, SLEEVES, BOOTS, HEAD & FACE PROT SHOULD BE WORN. THIS
(ING 13)
Work Hygienic Practices:USE GOOD PERSONAL HYGIENE PRACT. WASH HANDS
BEFORE EATING, DRINKING, SMKNG/USING TOILET FACILITIES. PROMPTLY
(ING 15)
Supplemental Safety and Health
SPEC GRAV:1-1.50 (H*2O=1 @ 29.2F). FIRE FIGHT PROC:BUILD PRESS/RUPTURE
CLSD CNTNRS, SPREAD FIRE, INCR RISK OF BURNS/INJURIES. WATER MAY BE
INEFTIVE IN FIRE FIGHT DUE TO LOW SOL. USE WATER SPRAY/FOG FO R
COOLING. PRESS RELIEF SYS MAY PLUG W/SOLIDS, INCR RISK OF
OVERPRESS. NOTIFY AUTH IF LIQ ENTERS SEWER/PUBLIC WATERS.
Chemical Properties
HCC:F4
Boiling Pt:B.P. Text:212F,100C
Spec Gravity:SUPDAT
Solubility in Water:NEGLIGIBLE
Appearance and Odor:CLEAR LIQUID; MILD ACRID ODOR.
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AND REDUCING AGENTS; INERT GASES.
Stability Condition to Avoid:HEAT, INERT ATMOSPHERES, DIRECT
LIGHT/SUNLIGHT.
Hazardous Decomposition Products:WHEN HEATED TO DECOMPOSITION, MAY EMIT
CARBON MONOXIDE, ACRID FUMES.
Conditions to Avoid Polymerization:HEAT, INERT ATMOSPHERES, DIRECT
LIGHT/SUNLIGHT, STRONG OXIDIZING & REDUCING AGENTS, INERT GASES.
Disposal
Waste Disposal Methods:CONTAMD PROD/SOIL/WATER MAY BE RCRA/OSHA HAZ
WASTE DUE TO POTNTL FOR INTERNAL HEAT GENERATION (40CFR 261 & 29CFR
1910). LANDFILL SOLIDS AT PERMITTED SITES. USE REGISTERED
TRANSPORTERS. BURN CONC LIQS IN SYS THAT USE COMPATIBLE FUEL.
DILUTE(ING 7)
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.